Black & White Drop Necklace

Project Sheet:
UPC #: 420004024886

Black & White Drop Necklace

Black & White Drop Necklace

Project Sheet:
UPC #: 420004024886

Materials

  • (3) "Darice" 8mm glass pearls, in Mystic Black (12'' strand)
  • (3) "Darice" 4mm Czech glass fire polished rounds, in Gunmetal AB (7'' strand)
  • (4) "Darice" 6mm glass pearls, in Mystic Black (12'' strand)
  • (4) "Darice" 4mm Flower spacer beads, in Silver (31pc pack)
  • (4) "Venezia Crystals" 4x6mm rondelles,in Black (7'' strand)
  • (4) White 6/0 e-beads
  • (Appx 20'') "Steampunk" Antique Silver Chain A (39'' spool)
  • (1 set) "Cousin" small silver toggle clasp (10pc pack
  • (11) Silver headpins
  • Round nose pliers
  • Flat nose pliers
  • Wire cutter

Directions

  1. Slide a gunmetal Czech bead and an 8mm pearl onto a headpin. Make a simple loop on top. Cut any excess wire with the wire cutter. (Make three.)
  2. Slide a flower spacer and a 6mm pearl onto a headpin. Make a simple loop on top. (Make four.)
  3. Slide an e-bead and a rondelle onto a heapin. Make a simple loop on top. (Make four.)
  4. Cut two piece of chain at about 11'' and 9''. Connect them so that there is a dangle in the middle of 13 links, and the sides are even.
  5. Connect one beaded headpin at the bottom of the dangle, either by opening up a chain link, or the headpin loop. Connect another one three links up. Repeat more times. The top headpin should land where the dangle and both sides meet up.
  6. Connect two matching headpins on either side of the middle dangle, four links over. Connect two more headpins another four links over, and the last two another four links over.
  7. Connect each side of the toggle clasp to the ends of the chain.

Leave a Comment