Let It Snow Plaque w/3 Squares
Project Sheet: cd2606
UPC #: 420004015051
Materials
- Rectangle Hanging Plaque w/ 3 Squares - CAL/63
- Acrylic Paint (Titanium White) - FolkArt
- Paper (I Love Winter Border Strips) -Echo Park
- Felt (Red)
- Vinyl (Mini Snowman Face) - Vinyl Words
- Baker's Twine - SPC
- Mod Podge
- Foam Brush
- Hole Punch
- Photos
- Paper Trimmer
- Scissors
Directions
- Remove rings from the plaque.
- Paint the wood all wood surfaces white. Let dry.
- Cut a 4-3/4" strip containing Let It Snow from the 12 x 12 "Border Strips" paper.
- Center the piece on the Rectangle, mark the ring holes with a pencil and punch them out.
- Glue the piece down onto the Rectangle, using Mod Podge, let dry.
- Cut two 4 x 4 pieces from the same paper, lay them over the square pieces and mark holes with a pencil and punch them out.
- Adhere them to two of the three squares.
- Adhere a photo onto each of the paper covered squares.
- Apply the snowman face vinyl to the third square, following instructions on vinyl packaging.
- Cut two roughly 1" strips from a red felt sheet.
- Glue the ends together to make one long piece.
- At the bottom of the snowman face square, wrap the felt around the square as a scarf. Cut the ends to make fringes.
- Using the white paint, dry brush all edges of all wood pieces to create a soft snowy look.
- Cut out some fun elements from the remaining paper and use them to embellish the plaque.
- Reattach the rings to connect all four pieces.
- Feed the bakers twine through the hanging hooks and tie a bow.
- Display.