Pearly Arrow Necklace

Project Sheet:
UPC #: 420004017307

Pearly Arrow Necklace

Pearly Arrow Necklace

Project Sheet:
UPC #: 420004017307

Materials

  • (1) “Steampunk” Antiqued Silver Arrow with Pearl charm (3 piece pack)

  • (5) “Darice” 8mm Glass Pearls, in White (12’’ strand

  • (Appx 1/3 tube) “Dazzle-It!” 6/0 e-beads, In Smoke Mix (24 gram tube)

  • (Appx 10’’) “Cousin” Silver Small Twist chain (46’’ length)

  • (Appx 10’’) “Darice” Aluminum Jewelry Wire, in Silver (3 yd spool)

  • (Appx 1.5’) “Beadalon” .018’’ or .024’’ Bead Stringing Wire (30’ spool)

  • (2 closed and 1 open) “Cousin” 6mm jump rings (300 piece set)

  • (4) Silver #2 Crimp Tubes

  • (1) Silver Clasp and Split Ring

  • Crimper

  • Nipper

  • Round Nose Pliers

  • Chain Nose Pliers

  • Wire Cutter

Directions

  1. Cut two pieces of bead stringing wire, at about 8’’ and 9’’. Attach them to a closed jump ring, using the crimper and two crimp tubes.
  2. On the shorter strand, string on 26 e-beads, a pearl, and 26 e-beads. Secure the other end to the other closed jump ring. On the longer strand, string on 16 e-beads, a pearl, 16 e-beads, the arrow charm (slide the open jump ring through the top first, so that it lays the correct way), 16 e-beads, a pearl, and 16 e-beads. Secure the end to the other closed jump ring.
  3. Cut two pieces of aluminum wire at about 5’’ each. Make a wrapped loop on one end using the round nose pliers. Slide on an e-bead, a pearl, and an e-bead. Make a wrapped loop at the other end.  Use the wire cutter to trim any extra wire, and the chain nose pliers to squish down the ends if they’re sticking out at all.
  4. Cut two pieces of chain at about one inch each. Attach one end to the beaded eyepins, and the other end to the closed jump rings that the two beaded strands are on.
  5. Cut two more pieces of chain at about 4’’ each. Attach one end to the open side of the beaded headpins, and the other end to the clasp and split ring.